Vertical Conical Ribbon Vacuum Dryer

Vertical Conical Ribbon Vacuum Dryer is usually used for mixing and stirring powder, granular materials, slurry or viscous material. It can be equipped with a liquid spray system, which can be designed into a vacuum state, a pressure state, and heating according to user requirements. Or cooling...

Product Details

Vertical Conical Ribbon Vacuum Dryer is usually used for mixing and stirring powder, granular materials, slurry or viscous material. It can be equipped with a liquid spray system, which can be designed into a vacuum state, a pressure state, and heating according to user requirements. Or cooling and other process conditions to meet the mixing and stirring of materials under various process conditions. Especially the specific gravity of the material is below 3g/cm3, and the liquid content is below 20%. Various powders and granules with certain fluidity.


1 

 

Conical Ribbon Vacuum Dryer is a kind of material that uses spiral belt to rotate and lift the material, and conical jacket and hollow spiral belt simultaneously pass heat transfer medium (such as hot water, thermal oil, steam, etc.) to make the heated material Lifting from all around and falling from the middle, rapid and continuous circulation and turning, and vacuuming the cylinder to take away water vapor in time, so that the material can be dried and mixed in a short time. Compared with the traditional vertical mixer, there is no transmission mechanism in the cylinder, which fundamentally eliminates the material pollution caused by the leakage of lubricating oil. The operation is reliable and stable. It is especially suitable for the mixing of powders and particles with high hygienic requirements; it is also suitable for Viscous fluid or thick and wet main materials are stirred and mixed; compared with other horizontal dryers, it has convenient discharge, 100% complete discharge, easy operation and maintenance. Its drying efficiency is 3-5 times that of the "double cone rotary vacuum dryer" of the same specification.

 

Vertical Conical Ribbon Vacuum Dryer Flow chart

2 

 

Vertical Conical Ribbon Vacuum Dryer The main function

◆Strong mixing effectMove the material close to the container wall upward and the material at the center downward

◆Soft but complete mixing of flowable materials, a large amount of materials can be mixed in a short time

◆It can achieve high standard mixing evenly

◆Almost all materials can be cleaned


Features:

◆Cantilever shaft structure, bearing end is not in contact with materials

◆The gap between the mixing paddle and the container wall is very small to prevent the material from sticking

◆Standardized mixing drive box to ensure stable operation and low maintenance cost

◆Appropriate shaft seal structure for each application, the shaft seal is installed away from the product, to ensure that the tried and tested CLARE MIXERS enterprise standard mixer seal is well used

◆Comply with GMP equipment design-O-ring with special geometry, high-quality equipment surface treatment and eliminate dead angle.

◆The machine is driven by the reducer to directly rotate the agitator.

◆Wide range of application, can be used for mixing powder and powder, powder and liquid, also can be used as reaction equipment, drying equipment.

◆A spray device can be added according to the user's requirements, so as to spray an appropriate amount of liquid into the material.

◆The speed can be adjusted according to the needs of the process. When the speed is low, the drying effect is dominant; when the speed is high. The mixing effect is dominant, so by using this equipment, you can use two kinds of equipment to achieve the purpose, and now you can combine them into one, saving costs.


Vertical Conical Ribbon Vacuum Dryer Structure

3 



Optional configuration:

◆Can be designed for vacuum or pressure operation

◆Can be equipped with hot and cold interlayer

◆The upper cover is designed into a head structure according to user requirements

◆Sealing device: standard packing seal, skeleton seal, mechanical seal

◆Discharge valve: ball valve, butterfly valve, gate valve are available

◆Configurable liquid spraying device

◆Adding shredding device, can shred any size polymer to meet the process requirements

 

4 


Can meet the technological conditions

1. Meet GMP and FDA standards.

2. Meet the vacuum, positive pressure, or high temperature operating conditions, when the vacuum or pressure reaches a certain level, and can maintain the pressure for a certain time.

3. The material can be loaded in vacuum to avoid flying dust when some light fine powder is manually fed.

4. The heating or cooling process can be carried out during the material mixing process.

5. Configure CIP online rotating cleaning spray ball for equipment cleaning.


5 


Hot Tags: vertical conical ribbon vacuum dryer, China, manufacturers, suppliers, price

Inquiry

You Might Also Like